FAAC 413 Swing Gate Motor

The FAAC 413 is rated to IEC duty class S3 at 30% — the only motor in the POWERgate Abu Dhabi range to specify the international IEC S3 motor duty classification. S3 is the IEC standard for intermittent periodic operation: the motor runs for a set cycle period, then rests, then runs again. At 30%, the motor operates for 30% of each period and rests for 70%. In practical terms, this equates to approximately 15–20 gate cycles per day at Abu Dhabi ambient temperatures — the standard residential villa usage level.

Without an electric lock, the FAAC 413 relies solely on its internal mechanical stops and rod self-locking to hold the gate closed. FAAC rates this sufficient for gate leaves up to 1.8m, beyond which wind loading and gate weight create more force at the latch point than the motor’s lock can reliably resist. Adding an electric lock provides a separate powered bolt at the gate post, extending the safely automatable leaf length to 2.5m. This 1.8m/2.5m threshold is unique to the FAAC 413 in the range — most motors specify a single maximum leaf length.

The FAAC 413’s horizontal cable exit routes cables sideways from the motor body rather than downward, enabling low or near-ground installation where the motor sits close to the driveway surface. On gate installations where the motor must be mounted low on the gate pillar — typically for heritage gates, low brick pillars, or aesthetic preference — a downward cable exit would require the cable to bend sharply or be routed underground immediately. The horizontal exit allows clean cable routing along the pillar base without tight bends that can damage cable insulation over time.

The FAAC 413 rear bracket supports both welded and screwed attachment — more flexible than motors requiring only welding (DEA MAC) or only screwing (DEA STING). Welding provides a permanent, vibration-proof mount and is preferred for heavy steel or iron gates where the 2000N thrust generates significant bracket stress. Screwing is suited to aluminium gates, powder-coated frames, or installations where future bracket repositioning may be needed. For Abu Dhabi villa gates made from welded iron or steel, welding is recommended. For aluminium or coated frames, correctly torqued bolts with appropriate thread anchors are adequate.

The FAAC 413 carries a 24-month manufacturer warranty backed by FAAC’s global reputation as a leading Italian automation brand. The 140°C thermal protection is lower than most motors in the range (usually 150°C), meaning the thermal cutout engages sooner under overload. Correct S3-30% usage is critical — exceeding the duty cycle triggers thermal protection repeatedly. If the gate leaf exceeds 1.8m, an electric lock from the included kit must be installed. The IP54 rating provides good dust and splash protection for exposed Abu Dhabi pillar positions. Contact POWERgate Abu Dhabi on WhatsApp (+971 50 884 4933) or sales@powergatead.com.