LIFE OP3 UNI DL Swing Gate Motor Kit

The LIFE OP3 UNI DL and LIFE Armor UNI DL are both surface-mounted LIFE motors sharing the same +70°C operating temperature, aluminium structure, and polyester outdoor coating. The OP3 uses 230V AC at 210W with a 337mm linear rod stroke, 2000N thrust, IP54, 35% intermittence, and 3m/700kg capacity. The Armor uses 24V DC at 40W with a jointed arm, 170Nm torque, IP44, and 80% intermittence for 2.5m gates. Choose the OP3 for heavier 230V installations up to 3m; choose the Armor for 24V smart installations on wide pillars requiring high duty cycling.

LIFE publishes the OP3’s maximum gate weight as up to 700 kg depending on leaf length and site conditions, referenced from a limit-on-use chart rather than a single figure. This reflects the physical reality that weight capacity and leaf length are interdependent: a 700 kg gate at 1.5m requires far less motor torque than 700 kg at 3.0m, and windy or exposed sites further reduce the safe working limits. The chart maps specific leaf-length and weight combinations against the motor’s 2000N thrust and 337mm stroke. LIFE also recommends an electric lock in windy conditions or for structurally particular gate panels.

LIFE’s 35% intermittence is consistent across its Optimo and ERGO motor ranges at both 230V and 24V, reflecting LIFE’s motor thermal management design standard. At 210W and 35%, the OP3 UNI provides approximately 18–22 gate cycles per day — slightly more than the 30% standard used by most competing 230V motors of comparable power. This extra 5% duty margin is particularly useful for Abu Dhabi villas with morning and evening peak gate demand from family vehicles, domestic staff, and deliveries, where a 30% motor can approach its limit on busy days.

The LIFE OP3 UNI DL kit includes a sign plate — a safety warning sign designed to be fixed to or near the automated gate, alerting pedestrians and vehicle occupants to the presence of an automated gate that opens and closes without manual intervention. This is a safety compliance accessory required under EN 12453 and related gate automation safety standards for residential and commercial automated gates. The LIFE OP3 kit is the only swing gate motor kit in the POWERgate Abu Dhabi range that explicitly lists a sign plate as a standard kit component, reflecting LIFE’s built-in safety compliance approach.

The LIFE OP3 UNI DL carries a 24-month manufacturer warranty. LIFE requires the gate weight and leaf length to be verified against the limit-on-use chart — exceeding the charted limit for any specific leaf length overloads the 2000N thrust and voids warranty. In wind-exposed Abu Dhabi locations, an electric lock is recommended even within the chart’s limits. The IP54 rating provides good outdoor protection for pillar-mounted installation. The pre-wired 1m cables are shorter than most motors and must reach the control unit without extension. Contact POWERgate Abu Dhabi on WhatsApp (+971 50 884 4933) or sales@powergatead.com.