V2 NYK Swing Gate Motor

The V2 NYK-24V draws 0.4A at idle speed (motor spinning freely without load) but up to 6A at full load — a 15:1 ratio that is the most extreme idle-to-load current ratio published in the POWERgate Abu Dhabi range. At 24V, the 6A peak corresponds to 144W peak absorption against the motor’s 80W rated power, reflecting a high startup current surge as the 24V motor overcomes gate inertia. The control unit and 24V power supply must both be sized for the 6A peak without voltage sag, which could prevent reliable gate startup on undersized supplies.

The V2 NYK-24V’s 50% duty cycle is significantly higher than the V2 CALYPSO 400’s 30% and the majority of 230V residential motors in the range. At 50%, the NYK-24V can operate for 30 minutes of every hour before thermal rest, making it suitable for above-average residential gate frequency. For Abu Dhabi villas with domestic staff, multiple family vehicles, regular deliveries, and visitor access throughout the day, 50% duty provides comfortable headroom. The 24V motor’s lower individual cycle heat generation also supports sustained operation within this rating.

The V2 NYK-24V includes adjustable fixing brackets that can be set to multiple positions without custom fabrication or on-site modification. The adjustability allows the bracket to accommodate different pillar face widths, gate leaf profiles, and C-distances without welding or drilling custom holes. For Abu Dhabi gate installers fitting motors across multiple villa properties with different pillar geometries, adjustable brackets reduce setup time per installation significantly. They also allow minor bracket position corrections during commissioning without removing and repositioning a fixed bracket.

The V2 NYK-24V is supplied with a mechanical opening limit stop built in, physically defining the gate’s maximum open position. The closing mechanical stop is available as a separate accessory, not included in the standard motor. Without a closing stop, the gate’s closed position is managed by the control unit’s timed motor run or a separate closing limit accessory. For Abu Dhabi installations where precise closing position is needed for latch alignment, the optional closing stop accessory should be ordered alongside the motor. POWERgate Abu Dhabi can supply the V2 closing stop accessory.

The V2 NYK-24V carries a 24-month manufacturer warranty. This listing supplies one motor only — a complete gate installation requires a 24V control unit rated for 6A peak motor current, radio receiver, remote controls, safety photocells, flashing light, and closing stop accessory if needed. The 24V power supply or transformer must handle 6A peak without voltage collapse. The IP44 rating requires sheltered pillar mounting. Contact POWERgate Abu Dhabi on WhatsApp (+971 50 884 4933) or sales@powergatead.com for compatible accessories.